Pot With Lid

Three minimalistic pots in three different sizes with lids! The pots can of course also be used without the lids, I have the edges on which the lid rests purposely kept simple. The model has no critical overhangs, so everyone should get a wonderful print result. By the way, this model can also be scaled very well. If you are unsure whether the lid will still fit into the pot if the size changes significantly, you can cut off the pot and print only the upper edge for testing. Please follow the printing instructions below to get the best result. Print instruction: I recommend printing the lids with a layer height of 0.2mm. 3 perimeters and 10% infill are sufficient. The slightly angled top of the lid should be printed with a layer height of 0.1 to 0.12mm for a much nicer result. This can be set via "Variable layer height" as shown in the picture. The color change is best set to the height where the diameter of the sphere is somewhat equal. But of course this is up to you. I recommend printing the pots with a layer height of 0.2 to 0.25mm. 3 perimeters and 10% infill are sufficient. From a height of 20mm, the infill can be set to 0%, the pot is still sturdy.

Screenshot 2022-11-21 at 11.41.26 AM.png 20221010_175619.webp potsmall_preview.webp 20221010_180403.webp 20221010_180039.webp 20221010_180109.webp 20221010_180500.webp model_generated_screenshot.png office garden kitchen